Ivoclar Vivadent IPS e.max CAD Abutment Solutions - Manual (Page 13)

13
Clinical W
orking Steps | Layer Thicknesses | Block Selection | Finishing
– Fabrication Hybrid Abutment and Hybrid Abutment Cr
own
Block selection
An IPS e.max CAD MO or LT block is selected depending on the indication.
When using a Ti base from Sirona, the dimensions of the interface to the Ti Base (S or L) have to be
observed.
CAD/CAM processing
As densification of about 0.2% occurs in IPS e.max CAD during crystallization, this factor has been taken
into account in the respective software of the tested CAD/CAM system. Consequently, the milled
IPS e.max CAD restorations demonstrate a high accuracy of fit after crystallization. The fabrication steps
are described in the directions for use and user manuals of the different CAD/CAM systems. The
instructions of the manufacturers must be followed.
IPS e.max CAD
hybrid abutment
IPS e.max CAD MO
(Medium Opacity)
Please refer to the table on
page 62 for the selection of
the block shade for the desired
tooth shade.
IPS e.max CAD crown
(on IPS e.max CAD hybrid abutment)
IPS e.max CAD LT
(Low Translucency)
IPS e.max CAD
hybrid abutment crown
IPS e.max CAD LT
(Low Translucency)