Harken HC9045 Battcar Switch System - Manual (Page 9)

07/21/11 26 mm/32 mm Battcar Switch System 9
Assembly Mounting Storage Tracks
Make sure storage track ends with holes
for endstop are at bottom. If shortening
is required, cut track from upper end
maintaining holes for endstop.
Fix bottom loader tracks by placing track
over splice and tapping into place using
plastic hammer.
Align track and tape in place. Use transfer
punch to mark hole. Remove track, drill
and tap. Fasten track using single screw.
Center punch another hole, drill, tap and
fasten track. Center punch remaining holes,
drill, tap and install using threadlocking
adhesive.
Assembly Mounting Gate Tracks
Carefully align track. Use transfer punch
to mark holes. Drill, tap and mount as
directed above.
IMPORTANT! Do not use threadlocking
adhesive on screws because gate track
is removed for loading cars.
With gate track off mast, use plastic hammer
to tap splice link into upper end of track.