Harken HC9045 Battcar Switch System - Manual (Page 8)

8 26 mm/32 mm Battcar Switch System 07/21/11
Assembly Mounting Switch
Insert three splice links into switch track.
Using a plastic hammer, tap them in place.
Carefully align track and tape in place.
Use a transfer punch to mark a single
hole.Remove and drill and tap. Fasten
with single screw, no adhesive.
Re-align and mark a second hole using
transfer punch. Screw to mast using two
screws, no adhesive.
Mark remaining holes using transfer punch.
Remove and drill and tap remaining holes.
Mount switch to mast using threadlocking
adhesive on screws as required.