Harken HC9045 Battcar Switch System - Manual (Page 11)

03/21/12 26 mm/32 mm Battcar Switch System 11
Commissioning Load Cars on Track
Remove gate track.
Install cars from above switch.
Lubricate cars onshore before loading.
Before bringing headboard assembly or cars
onboard boat, spray underbody track slot
(see arrows above) with a light coating of
McLube™ Sailkote™.
Note: Mustard-colored pegs on foot of car
guide it to correct side. Car will go to side
of track where there are no pegs.
Tip:
Plain foot to right, car goes to right.
Plain foot to left, car goes to left.
WARNING! Overspray from McLube
will cause slippery decks which may
result in loss of footing. Cover decks
or spray cars off boat.