Harken HC9045 Battcar Switch System - Manual (Page 2)

2 26 mm/32 mm Battcar Switch System 07/14/11
Tools
2
1
4
8
9
3
6
1.Tape measure 8. Tape
2. Power drill 9. File
3. Drill bits 10. Hex key
4. Hammer 11. McLube ™ Sailkote ™
5. Plastic hammer 12. Tap for mast mounting holes (not shown)
6. Hacksaw
7. Transfer punch
Threadlocking adhesive for mast screws
11
10
Introduction
WARNING! Strictly follow all instructions to avoid potential hazards that may
kill or hurt you and others. See www.harken.com/manuals for general warnings
and instructions.
WARNING! This symbol alerts you to potential hazards that may kill or hurt you and others
if you don't follow instructions. The message will tell you how to reduce the
chance of injury.
This manual gives technical information on installation and service. This information is destined exclusively
for specialized personnel or expert users. Installation, disassembling, and reassembling by personnel who are
not experts may cause serious damage to property or injury to users and those in the vicinity of the product.
If you do not understand an instruction contact Harken.
The user must have appropriate training in order to use this product.
Harken accepts no responsibility for damage or harm caused by not observing the safety requirements and
instructions in this manual. See limited warranty, general warnings, and instructions in www.harken.com/manuals.
Purpose
Harken battcars are designed to reduce the size of or completely drop the mainsail on a sailboat so wind has little
effect on the sail. Use of this product for other than normal sailboat applications is not covered by the limited warranty.
Safety Precautions
CAUTION! This symbol alerts you to potential hazards that may hurt you and others if
you do not follow instructions. The message will tell you how to reduce the
chance of injury.
7