Harken 1807, 1807HL System A Battcars: built before 2005 - Manual (Page 7)

7
1
Slip the slugs for the
top track into the mast
groove starting with 1 1 /
4
"
(32 mm) end stop slug.
Make sure the 2
5 /
8
"
(67 mm) connector
slug is at the bottom.
If the mast is up, tape 1
1 /
4
"
(32 mm) slug in place so
it will be even with the top
of the upper track.
Tape the other slugs
in place.
Installing Track
2
Put a drop of blue
Loctite into each
connector slug hole.
3
Thread a 1" (25 mm)
long end stop screw
through the rubber end
stop, track and into end
stop slug.
If the mast is up, remove
the tape and tighten the
screw enough to hold
the track in place.
Loosely install the other
1" (25 mm) screw.
4
Use a putty knife to
slide the next slugs
into place and loosely
install the 5 /
8
" (16 mm)
screws.
5
Loosen the top screw
and slide the top track
up far enough to place
the next 6'8 3 /
4
" (2.05 m)
track in place.
Mast up: tighten bottom
screw to hold the track
in place.
6
Slide 15 mounting
slugs and a connector
slug into the mast groove.
Mast up: tape in place.
Put a drop of blue Loctite
in each hole.
Tip: Use the putty knife
as a feeler gauge to
make sure the screws
are loose enough to
slide easily in the
groove.
REMEMBER: The tracks
may slide up the lower
part of the mast but
may hang up when they
reach a spliced area of
the mast.