Harken 1807, 1807HL System A Battcars: built before 2005 - Manual (Page 11)

11
Loading Sail On Car
Once hardware is installed on sail, load it
on cars beginning with the lower ones.
Luff cars
Remove clevis pin, place plastic center sleeve
between tangs and slip clevis in place. Secure
with cotter pin. Make sure that webbing is not
twisted.
1944 Car
Slip clevis pin through car and secure with
cotter pins.
Battcars: Slip a plastic bushing into each
end of the car lug.
Insert the shaft of the Battslide fitting
into the barrel so the threaded end
points up.
You must use a
5 /
16
" (8 mm) washer
between the plastic shaft-bushing and
the nut. See Diagram B.
Tighten the locknut until you begin to
feel the shaft of the Battslide bind when
you rotate it in the car.
Loosen the locknut 1/8 turn from this
point.
Tightening the locknut too tightly or
failing to use a washer will damage
the plastic liner.
Headboard
Attach headboard of sail to the
headboard coupler.
Raise sail and check to make sure
that sail is not too tall.
If necessary, have sail shortened.
1976, 1901 cars With Battslide Receptacle
DIAGRAM B