Harken 1807, 1807HL System A Battcars: built before 2005 - Manual (Page 3)

1800 TRACK, 6'8 3 /
4
" (2.05 m) long:
Number of sections will vary according
to luff length.
Make sure you have the correct size track.
System A track is 7 /
8
" (22 mm) wide.
2720 Track: for drilling and tapping
you must use 2720 track. Use 10-32
(5 mm) screws, not included.
Do not use 1800 open backed track
for drilling and tapping the mast. This
track must have the support of the
mounting slugs.
See page 9 for mounting instructions.
3
Sizing
Make sure that you have the correct size
Battcar system for your boat.
Maximum Sail Area
System Headboard
Monohull Multihull
Part No.
Battcars
Luff
Car
350 ft2
33 m2
300 ft2
28 m2
A
Low Load
1807 1901, 1944,
1976, 1977
1777
550 ft2
51 m2
425 ft2
39 m2
475 ft2
34 m2
350 ft2
32 m2
A
Hi-Load
A
1792HL
1792
1807
1825HL, 1901HL, 1944HL,
1976HL, 1977HL
1825, 1901,
1944, 1976
1894HL
1894
Parts List
BATTCARS
Harken fitting is shown.
You may have Battslide,
Rutgerson or SDA batten
receptacles supplied
separately.
LUFF CARS
Luff cars not required
if battens are close
enough to support sail.
MOUNTING KIT
One required for each track.
END KIT
One required for each system.
HEADBOARD ASSEMBLY
2 -
Headboard
Cars
1 - Coupler
2 -
Headboard Plates
(1792 Only)
1807
4 - 19 mm Rings
1 -
Screw and
Nut for
1944
Receptacle
15 - Mounting Slugs
3 / 4 " (19 mm)
1 - Connector Slug
2 5 /
8
" (67 mm)
2 - Tubes
Blue Loctite ®
17 - Flathead Screws
5 mm x 16 mm
1792
2 - End Stops
1 1 /
4
" (32 mm)
4 - Flat Head Screws
5 mm x 25 mm
2 - Rubber End Stops
1 - Tube
Blue Loctite ®
1 /
2
"
(12 mm)
7 /
8
" (22 mm)
7 /
8
" (22 mm)
1 /
2
"
(12 mm)