Harken 1027 MKIII Hydraulic Jib Reefing & Furling - Manual (Page 23)

7/17/08 Hydraulic 3/3.25 23
■ BEFORE OPERATION
TIP: Label buttons “in” and “out” and be consistent in their
use when rolling and unrolling sail. This way, it will be
possible to furl in tdesired direction at night when sail
is hard to see.
TIP: Use a short 8" (200 mm) handle to increase furling
speed furling.
WARNING!: Before operating, consult pages on
halyard lead angle. If sails are changed, make
sure halyard lead angle is correct. A halyard wrap
cannot be tolerated on a hydraulic furler In severe
cases, a halyard wrap can cause loss of control of
boat and/or headstay can break suddenly which can
cause an accident, damage to your vessel, personal
injury or death. See www.harken.com for additional
safety information.
Adjustments Before Operation/Manual Operation
■ MANUAL OPERATION
To furl or unfurl the unit manually, push the lever to manual
and insert a winch handle in the starboard socket. Rotate to
move the sail in or out.
CAUTION!: Do not use hydraulic furler to sheet sail.
Make sure to ease sheets before operating the system.
The direction of furling is up to the individual. Make sure
suncover is rolled correctly.