Configuration file download – Grandstream GXP2130 Administration Guide User Manual
Page 81
GXP2130/GXP2140/GXP2160
FIRMWARE VERSION 1.0.4.23
GXP2130/GXP2140/GXP2160
ADMINISTRATION GUIDE
Page 79 of 81
CONFIGURATION FILE DOWNLOAD
Grandstream SIP Devices can be configured via the Web Interface as well as via a Configuration File
(binary or XML) through TFTP or HTTP/HTTPS. The "Config Server Path" is the TFTP or HTTP/HTTPS
server path for the configuration file. It needs to be set to a valid URL, either in FQDN or IP address format.
The "Config Server Path" can be the same or different from the "Firmware Server Path".
A configuration parameter is associated with each particular field in the web configuration page. A
parameter consists of a Capital letter P and 2 to 3 (Could be extended to 4 in the future) digit numeric
numbers. i.e., P2 is associated with the "New Password" in the Web GUI->Maintenance->Web Access
page->Admin Password. For a detailed parameter list, please refer to the corresponding firmware release
configuration template.
When the GXP2130/GXP2140/GXP2160 boots up or reboots, it will issue a request to download a
configuration XML file named "cfgxxxxxxxxxxxx.xml" followed by a file named "cfgxxxxxxxxxxxx", where
"xxxxxxxxxxxx" is the MAC address of the phone, i.e., "cfg000b820102ab.xml" and "cfg000b820102ab". If
the download of "cfgxxxxxxxxxxxx.xml" file is not successful, the provision program will download a
generic cfg.xml file. The configuration file name should be in lower case letters.
For more details on XML provisioning, please refer to: