Grandstream GXP2130 Administration Guide - Manual (Page 46)

GXP2130/GXP2140/GXP2160
FIRMWARE VERSION 1.0.4.23 GXP2130/GXP2140/GXP2160
ADMINISTRATION GUIDE Page 44 of 81
highest) than this value the call will be held and multicast page will be
played. The default setting is “Disabled”.
Paging Priority Active
If enabled, during a multicast page if another multicast is received with
higher priority (1 being the highest) that one will be played instead. The
default setting is “Disabled”.
Multicast Paging Codec
The codec for sending multicast pages, there are 5 codecs could be
used: PCMU, PCMA, G.726-32, G.729A/B, G.722(wide band). The
default setting is “PCMU”.
Multicast Listening
Defines multicast listening addresses and labels. For example:
“Listening Address” should match the sender’s Value such as
“237.11.10.11:6767”
“Label” could be the description you want to use.
For details, please check the “Multicast Paging User Guide” on our
Website.
Settings -> Ring Tone
Call Progresses Tones:
System Ring Tone
Dial Tone
Second Dial Tone
Message Waiting
Ring Back Tone
Call-Waiting Tone
Busy Tone
Reorder Tone
Configures ring or tone frequencies based on parameters from local
telecom. The default value is North American standard. Frequencies
should be configured with known values to avoid uncomfortable high
pitch sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing (“On time” in ‘ms’) while OFF is the period of
silence. In order to set a continuous ring, OFF should be zero. Otherwise
it will ring ON ms and a pause of OFF ms and then repeat the pattern. Up
to three cadences are supported.
Call Waiting Tone Gain
This adjusts the call waiting tone volume. Users can select "Low",
"Medium" or "High". The default setting is "Low".
Settings -> Audio Control
Headset Key Mode
When headset is connected to the phone, users could use the HEADSET
button in "Default Mode" or "Toggle Headset/Speaker".

Default Mode:
 When the phone is in idle, press HEADSET button to off hook
the phone and make calls by using headset. Headset icon will
display on the screen in dialing/talking status.
 When there is an incoming call, press HEADSET button to pick