Grandstream GXP2130 Administration Guide - Manual (Page 59)

GXP2130/GXP2140/GXP2160
FIRMWARE VERSION 1.0.4.23 GXP2130/GXP2140/GXP2160
ADMINISTRATION GUIDE Page 57 of 81
into the phone.
Firmware File Postfix
Enables your ITSP to lock firmware updates. If configured, only the
firmware with the matching encrypted postfix will be downloaded and
flashed into the phone.
Config File Prefix
Enables your ITSP to lock configuration updates. If configured, only the
configuration file with the matching encrypted prefix will be downloaded and
flashed into the phone.
Config File Postfix
Enables your ITSP to lock configuration updates. If configured, only the
configuration file with the matching encrypted postfix will be downloaded
and flashed into the phone.
Allow DHCP Option 43
and Option 66 Override
Server
Default setting is “Yes”. DHCP option 66 originally was only designed for
TFTP server. Later on it was extended to support an HTTP URL. GXP
phones support both TFTP and HTTP server via option 66. Users can also
use DHCP option 43 vendor specific option to do this. DHCP option 43
approach has priorities.
Allow DHCP Option 120
to override SIP Server
Enables DHCP Option 120 from local server to override the SIP Server on
the phone. The default setting is "No".
3CX Auto Provision
Enables automatic provision feature on the phone when 3CX is used as the
SIP server. The default setting is "Yes".
Automatic Upgrade Enables automatic upgrade and provisioning. The default setting is "No".
Hour of the Day (0-23)
Defines the hour of the day to check the HTTP/TFTP server for firmware
upgrades or configuration files changes. The default value is 1.
Day of the Week (0-6)
Defines the day of the week to check HTTP/TFTP server for firmware
upgrades or configuration files changes. The default value is 1.
Authenticate Conf File
Authenticates configuration file before acceptance. The default setting is
"No".
Download Device
Configuration
Click to download phone ’s configuration file in .txt format.
Upload Device
Configuration
Upload configuration file to phone.
Maintenance -> Syslog
Syslog Server The URL or IP address of the syslog server for the phone to send syslog to.
Syslog Level
Selects the level of logging for syslog. The default setting is "None". There
are 4 levels: DEBUG, INFO, WARNING AND ERROR.
Syslog messages are sent based on the following events: