Grandstream GXP2130 Administration Guide - Manual (Page 33)

GXP2130/GXP2140/GXP2160
FIRMWARE VERSION 1.0.4.23 GXP2130/GXP2140/GXP2160
ADMINISTRATION GUIDE Page 31 of 81
ACCOUNTS PAGE DEFINITIONS
Table 8: Account Page Definitions
Account x -> General Settings
Account Active This field indicates whether the account is active. The default setting is "Yes".
Account Name The name associated with each account to be displayed on the LCD.
SIP Server
The URL or IP address, and port of the SIP server. This is provided by your
VoIP service provider (ITSP).
Secondary SIP Server
The URL or IP address, and port of the SIP server. This will be used when the
primary SIP server fails.
Outbound Proxy
IP address or Domain name of the Primary Outbound Proxy, Media Gateway,
or Session Border Controller. It's used by the phone for Firewall or NAT
penetration in different network environments. If a symmetric NAT is detected,
STUN will not work and ONLY an Outbound Proxy can provide a solution.
BLF Server
Optional server used for SUBSCRIBE requests to indicate other extensions
status on the SIP server.
SIP User ID
User account information, provided by your VoIP service provider (ITSP). It's
usually in the form of digits similar to phone number or actually a phone
number.
Authenticate ID
SIP service subscriber's Authenticate ID used for authentication. It can be
identical to or different from the SIP User ID.
Authenticate Password
The account password required for the phone to authenticate with the ITSP
(SIP) server before the account can be registered. After it is saved, this will
appear as hidden for security purpose.
Name
The SIP server subscriber's name (optional) that will be used for Caller ID
display.
Voice Mail User ID
This parameter allows you to access voice messages by pressing the
MESSAGE button on the phone. This ID is usually the VM portal access
number. For example, in UCM6100 IPPBX, *97 could be used.
Account x -> Network Settings
DNS Mode
This parameter controls how the Search Appliance looks up IP addresses for
hostnames. There are four modes: A Record, SRV, NATPTR/SRV, Use
Configured IP. The default setting is "A Record". If the user wishes to locate
the server by DNS SRV, the user may select "SRV" or "NATPTR/SRV".
If "Use Configured IP" is selected, please fill in the three fields below:

Primary IP:

Backup IP 1;