Grandstream GXP2130 Administration Guide - Manual (Page 45)

GXP2130/GXP2140/GXP2160
FIRMWARE VERSION 1.0.4.23 GXP2130/GXP2140/GXP2160
ADMINISTRATION GUIDE Page 43 of 81
Disconnect remotely. The default setting is “No”.
Disable Direct IP Call Disables Direct IP Call. The default setting is "No".
Use Quick IP Call mode
When set to "Yes", users can dial an IP address under the same
LAN/VPN segment by entering the last octet in the IP address. To dial
quick IP call, off hook the phone and dial #XXX (X is 0-9 and XXX
<=255), phone will make direct IP call to aaa.bbb.ccc.XXX where
aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet
mask. #XX or #X are also valid so leading 0 is not required (but OK). No
SIP server is required to make quick IP call. The default setting is "No".
Disable Conference Disables the Conference function. The default setting is "No".
Disable in-call DTMF Display
When it's set to "Yes", the DTMF digits entered during the call will not be
displayed on phone LCD. The default setting is "No".
Enable sending DTMF via
specific MPKs
Enables certain MPKs to send DTMF during the call. This option does
not affect Dial DTMF. The default setting is "No".
Mute Key Functions While Idle
Specifies the function of mute key in idle. Default setting is “DND”. When
select “Idle Mute” and press Mute key while idle, the future incoming call
will be answered with mute. When select “Disabled”, Mute key will not
take effect while idle. The default setting is “No”.
Disable Transfer Disables the Transfer function. The default setting is "No".
In-call dial number on pressing
transfer key
Configures the number for the phone to dial as DTMF during the call
using TRAN button.
Auto-Attended Transfer
If set to "Yes", the phone will use attended transfer by default. The default
setting is "No".
Do Not Escape # as %23 in
SIP URI
Specifies whether to replace # by %23 or not for some special situations.
The default setting is "No".
Click-To-Dial Feature
Enables Click-To-Dial feature. If this feature is enabled, user could click
the green dial button on left top corner of phone’s Web GUI, then choose
the account and dial to the target number. The default setting is
"Disabled".
Call History Flash Writing:
Write Timeout
Defines the interval (in seconds) to save the call history to phone's flash.
0 means this option is disabled. The default value is 300 seconds.
Call History Flash Writing:
Max Unsaved Log
Defines the number of unsaved logs before written to phone's flash. 0
means this option is disabled. The default value is 200 entries.
Settings -> Multicast paging
Paging Barge During active call if incoming multicast page is higher priority (1 being the