Start-up commands – Gasboy 1000 Series to FleetKey Conversion Manual User Manual

Page 16

Text mode
Original mode

Series 1000 to FleetKey Conversion

03/07/03

START-UP COMMANDS

Use the following commands to set up the system at the initial start-up. The Series 1000 FleetKey
Operation Manual describes these commands in more detail. In the examples, bold represents
the information that you enter, and this symbol

↵

represents the RETURN key.

Press CTRL F or RETURN. The system displays: SIGN ON:

2. Type

GASBOY and press RETURN. (The word GASBOY is shown in the illustration for

example only. You will not see the word GASBOY as you are typing it.) The asterisk prompt

appears indicating that you are in Command Mode and can begin entering commands to

configure your Series 1000 System.

UECPÂQP0ÂC7U8Qa

↵

3. Type

LS to change the initial password (GASBOY) to one of your choice (up to 10

characters).

Â
HUÂ
R7UUYQT@0ÂR7UUYQT@

↵