Gasboy 1000 Series to FleetKey Conversion Manual - Manual (Page 10)

Series 1000 to FleetKey Conversion
03/07/03 5
5. Working inside the head of the unit, remove the 2 screws which secure the optical reader
bracket to the face of the unit (the same 2 screws secure the bottom of the external card
reader cover assembly). Remove the entire optical reader assembly from the head of the
unit.
6. Working inside the head of the unit, remove the remaining 2 screws which secure the
external card reader cover assembly to the face of the unit. NOTE: Be careful when
removing the external cover assembly from the face of the unit because the optical reader
adaptor plate will come off with it. Save the external cover assembly and the four screws that
secured it to the face; you will re-install them later. The optical reader adapter plate will not
be reused.
7.
Proceed with the Installation of Key System instructions.