Important information – Gasboy PA03660XXX User Manual
Page 7
MDE-4705 Additional Serial Ports Installation on an Integral Profit Point System (PA03660XXX) · October 2007
Page 7
Installation Instructions
9
Insert the COM PCB into the unused ISA slot such that the connectors on the PCB protrude
through the expansion slot. Secure the board using the screw that was removed in step
10
Reassemble the Integral Profit Point PC by replacing the outside cover. Secure it with screws
removed in step
Note: Ensure that you do not pinch any cables or wires when you replace the outside cover.
Due to the addition of this ISA Serial Port Board, the existing serial ports will be re-
numbered.
IMPORTANT INFORMATION
11
Attach the Monitor, Keyboard, Mouse, Port 1, Port 2, and 4-port fan-out cables as they were
connected previously, on the back of the PC. The cables currently connected to the 4-port fan-
out cable 9-pin connectors have to be reconnected as shown in the table below.
Cable
Old Connection
New Connection
PIN Pad Communications (Serial
3 of POS Distribution Box)
Connector labeled S1
First port on new Serial Board (connector on
right, viewed from rear of PC)
Receipt Printer Communications
Connector labeled S2
Second port on new Serial Board (connector
on left, viewed from rear of PC)
Reader or Pump Interface
Communications
Connector labeled S3
Connector labeled S1
Reader or Pump Interface
Communications
Connector labeled S4
Connector labeled S2
12
Turn on the PC and enter the CMOS setup (press DELETE while PC is initializing).
13
Under Integrated Peripherals, disable the Onboard Parallel Port. Under PNP/PCI
Configurations, assign IRQ 5 and 7 to Legacy ISA. Save these changes and exit CMOS setup.
14
Once the PC has booted, log on to NT as the System Administrator.
15
Click Start > Settings > Control Panel. The control panel window will have one of the
following two icons for the existing PCI 4-port board in the PC - Siig Cyber PCI 20X or
Advanced Ports. Once you identify the icon, double click it.
Note: Follow the steps listed in the section
“Siig Cyber PCI 20X” on page 8
if the icon you
see is Siig Cyber PCI 20X. If the icon is Advanced Ports, skip to the section
.