Gasboy Quarles NBS - Manual (Page 27)

MDE-4643 Quarles NBS Configuration and Software Installation Manual · March 2007 Page 23
Appendix C - 3.3 to 3.4K Upgrade Instructions
The upgrade instructions should be used by trained CFN technicians when upgrading a
Quarles location from version 3.3X to 3.4K. They are not universal installation instructions.
The following procedures are applicable only for Quarles locations and should not be
attempted with any other site software.
Creating Backups
To stop the site and create a backup, proceed as follows:
1 Clear the fuel island.
2 Type STOP at the command prompt to shut down the site.
3 Settle all pending network transactions.
4 Type TRANBACK to create a backup of the transactions.
Note: Transactions will not be restored after the upgrade.
5 Type SYSBACK to create a backup of the site data.
Preparing the System for Upgrade
To prepare the system for upgrade, proceed as follows:
1 Log on to the CFN as the Administrator.
2 Close the CFN III program.
3 Insert the 3.4K customer disk.
4 Navigate to Start > Run, type CMD and press Enter.
5 Type A: Backup.
Installing the Upgraded Software
To install the software upgrade, proceed as follows:
1 Insert the 3.4K CD. Wait for 15 seconds for the Auto Run screen to appear.
2 Click Install. The Open option is highlighted.
3 Click Ok. The Welcome window appears.
4 Click Next.