Gasboy Voyager Special Card Handler - Manual (Page 17)

MDE-4410 Gasboy Voyager Special Card Handler Version 001 · June 2005 Page 13
Configuration
Other Configurations
Reader
• The Auxiliary number prompt at the reader is no longer configured for a supervisor card.
The TRFMT will define the prompt name and maximum number of digits that can be
entered.
• The Odometer prompt should be “Enter Odometer #” with the number of digits set to 6.
The Odometer prompt step must come before the verify prompt and select pump step.
Console
The Auxiliary number prompt at the reader is no longer configured for a supervisor card.
The TRFMT will define the prompt name and maximum number of digits that can be
entered.
sys_par Receipt Configuration
If the odometer reading is desired on the receipt, configure the odometer to be printed and
set the odometer message to “Odometer #.”
Gasboy Auth Codes
• Auth code 0 (zero) should be loaded with allowed fuels. If not, only merchandise will be
allowed. Auth code 0, with Voyager Club Card, is to allow all products.
• Auth code 1 should be loaded with fuels only. The Voyager Club Card for Auth code 1 is
for fuel only.
CFN III Characteristics
When a supervisor card is used inside, prompting for a manually-entered number is done from
the POS keyboard and display. If a PIN pad is attached to the POS system, the odometer
prompt will be displayed on the PIN pad display and the odometer number is entered on the
PIN pad keypad. Prompting on the POS terminal for the manually-entered number is the
standard method using a supervisor card.
Voyager Cards that request a manually-entered prompt are converted to a Gasboy Club
supervisor card. All prompts will appear at the dispenser or Island Card Reader (ICR), unlike a
sale from the POS terminal.