Gasboy SDI Interface - Manual (Page 9)

2 UNITEC Interface SCIII
Gasboy CFN Series
Gate configuration
Use the disk-based configuration program GATE to see the configuration submenus for
the car wash information.
Gate SubMenus
The following is a list of the submenus currently available for the gate and gate
controllers.
1 = Gasboy gates
2 = Gasboy gate controller
3 = Unitec Wash parameter
4 = Unitec Wash types
5 = Unitec Wash discounts
6 = Quit
Unitec Wash Parameters
To change the
parameters of the
car wash, select
submenu 3, Unitec
Wash Parameters
from the Gate Menu.
The items you can configure in the Unitec wash parameters are:
• Reader car wash prompt line 1 [What type of car wash]: Enter the first line of
the display. The default will be displayed between the brackets. Enter additional
information for lines 2-4 if needed. This information will be displayed at the
card reader.
• Price code for car wash prices [0]: The car wash driver uses this one price
CODE for all car washes. Each car type uses the price LEVEL corresponding to
its type. For example, car wash type 42 will use price level 42 of the price code
configured here. The price code you assign here must be entered on the site
using the Load Price command.
• Days car wash code valid [0]: The Unitec car wash controller does not remove
wash codes from memory automatically. This must be done with a user com-
mand at the Unitec console. The number of days listed here is to tell customers
how often you plan to clear the Unitec memory.
Unitec Wash Types
To change the types of the car wash, select submenu 4, Unitec Wash Types from the
Gate Menu. If an ICR does not recognize the selection Car Wash, check that you have
entered the car wash types in this screen.
# Description
1 Reader car wash prompt line 1: what type of wash
2 line 2:
3 line 3:
4 line 4:
5 Car wash price code: 0
6 Days carwash code valid: 0
------------------------------------------------------
Enter number of parameter to modify or q to quit: