Gasboy Hand Drive Kit - Manual (Page 6)

© 2006 GASBOY
7300 West Friendly Avenue • Post Office Box 22087
Greensboro, North Carolina 27420
Phone 1-800-444-5529 •
http://www.gasboy.com • Printed in the U.S.A.
MDE-4557 Atlas™ Hand Drive Kit M06874K001 Installation Instructions • July 2006
.
Atlas ™ is a trademark of Gasboy.
3 Apply grease liberally to the pulley stud (K85561) and inside the hub bore of the hand drive
pulley.
4 Insert the pulley stud into the hand drive pulley hub and screw it into the bearing on the pulley
bracket.
5 Insert and tighten the set screw (Kl8719) into the bracket bearing.
6 Place the shaft and hub hand drive assembly (M05767A001) on the pump support plate and
insert two M8X18 self-threading screws.
7 Place the shorter belt (R06711-75) over the small outer pulley on the pumping unit and the
inner pulley on the hand drive shaft and hub assembly.
8 Place the longer belt (R06711-61) over the large outer pulley on the hand drive shaft, hub
assembly and the large hand drive pulley.
9 Adjust the belt’s tension by sliding the shaft and hub assembly using the slots on the assembly
bracket and tighten the two M8Xl8 screws.
Completing the Installation
1 Insert the hand drive crank assembly (N18539) into the hand drive pulley (R13824-02) and
test the hand drive by dispensing some fuel into an approved container.
2 Remove the hand drive crank assembly (N18539) and place the lower panel door and lock it.
3 Inform the manager/owner that power will be restored to the unit.
4 Restore power using normal procedures.
5 Remove the lockout/tagout and return to normal operation.