Gasboy Battery Heater Kits User Manual
Introduction, Intended users, Required reading
Table of contents
Document Outline
- Introduction
- Important Safety Information
- Installing the Atlas Battery Heater Kit
- Preparing for the Installation
- Installing the Atlas Battery Heater Kits
- 1 Unlock and remove the front panel.
- 2 Remove the two screws securing the bezel assembly and remove the assembly.
- 3 Remove the two screws securing the display panel and pivot display panel down. The unit will swing forward and down after screws are removed.
- 4 Locate and identify the following parts in the Heater Kit:
- 5 Secure the thermostat to the standoffs using 6-32 screws.
- 6 Remove the adhesive backing from the heater strip. Press the heater strip to the upper barrier plate. Install the flat washers, place the heater cover plate, and secure it with two M4 screws. You may have to move the pulser to do this.
- 7 Connect the heater cable to the power bracket connector labeled HEATER.
- Completing the Installation
- 1 Reassemble pump (fasten display panel in place, install and secure the bezel assembly, and install and lock the front panel).
- 2 Inform the manager/owner that the circuit breakers for MICRO, LIGHTS and FEED will be turned on and then turn them on.
- 3 Remove the lockout/tagout and return to normal operation.