Gasboy External Filter - Manual (Page 6)

Installation of the Kit
Gasboy ® is a registered trademark of Gilbarco Inc. UL ® is a registered trademark of Underwriters Laboratories Inc.
© 2007 GASBOY
7300 West Friendly Avenue · Post Office Box 22087
Greensboro, North Carolina 27420
Phone 1-800-444-5529 ·
http://www.gasboy.com · Printed in the U.S.A.
MDE-4528A Gasboy® External Filter Kit Installation Instructions · November 2007
9 Install assembly from steps 6 through 8 to 45° elbow (P/N 024877) installed in step 5.
10 Install the filter elements (not shown in Figure 1 on page 5 ) to filter adapter (P/N 025903).
Notes:1) Standard filter element (P/N 025900) removes particulates only; Hydrosorb filter
element (P/N 25901) removes water and particulates.
2) For operating environments with temperatures below 0° F (-17° C), use the cold
weather blue fluorosilcone filter gaskets.
11 Remove the existing filter from the solenoid valve and filter manifold and replace with filter
cap and gasket (P/N R18896-G1 - not shown).
12 Dispose of any fuel or absorbent material properly.
13 Remove the existing nozzle hook and retain screws.
14 Install the nozzle hook (P/N 003719 - not shown) using screws from step 13 .
15 Put the unit into service and check for leaks and proper operation.