Gasboy NPT Disch Kit User Manual
Page 8
Installing Atlas NPT Discharge Kit (M06648K001)
© 2005 GASBOY
7300 West Friendly Avenue • Post Office Box 22087
Greensboro, North Carolina 27420
Phone 1-800-444-5529 •
• Printed in the U.S.A.
MDE- 4533 Instructions for Installing Atlas NPT Discharge Kit (M06648K001) • December 2005
5
Slide the discharge mounting bracket (M06642B001) over the nipple.
6
Inserting the open nipple end through the discharge hole in the frame, insert the discharge
fitting (M04624B020) into the meter discharge and place and tighten the (2) screws
(M00415B011).
7
Slide the discharge blanking plate (M06432A002) over the nipple protruding on the outside of
the unit so that the attached clinch-studs are inserted through the frame.
8
Slide the discharge mounting bracket (M06642B001) to the frame capturing the clinch studs
on the blanking plate through the holes in the discharge mounting bracket. Place (4) M8
flanged nuts (M00414B003) to the studs and tighten.
9
Slide the U-bolt (M00703B001) through the holes on top of the discharge mounting bracket so
that it captures the nipple. Place (2) M8 flanged nuts (M00414B003) to the U-bolt and tighten
them.
10
Slide the discharge grommet (028960) over the end of the nipple to where the rear face of the
grommet is against the blanking plate.
11
Apply pipe sealant to the threads of the 1-inch painted elbow (024895), screw it onto the
nipple and tighten the elbow.
Note: While tightening the elbow, use a cloth to wrap the elbow or some other means of
protecting the elbow’s finish.
12
Reattach hoses and hardware. After purging air from unit, check for leaks.