Gasboy 120VAC Heater Kit - Manual (Page 2)

Page 2 C35403 Rev. 8120
7. From the CPU PCB, pull off the AC, pulser, and
handle cables (a). From the RS-485 PCB or
Pump I/F PCB, pull off the DC cable (b).
Disconnect the red, blue, orange, and black
wires from screws 1 and 2 of the pump relays
(c). Push all of the cables down through the
platform bushings.
8.
On one of the display panels, pull off the ribbon cables (a) from the LCD Display PCBs and the power cables (b) from
the LED Backlight PCBs. Remove one end of the ground braid cable (c) from the display panel. Disconnect the
fluorescent lamp cable (d) from its mating connector mounted to the platform base. Remove the two screws (e) from
one of the support brackets. Be careful not to let the display panel fall while removing the support bracket. Slide the
panel away from the remaining support bracket and pull it out of the cabinet.
9.
Disconnect the LIGHTS and MICRO connectors from the power bracket.