Gasboy 120VAC Heater Kit - Manual

C35403 Rev. 8120 Page 1
INSTRUCTIONS FOR 120 VAC (C06481) AND 240 VAC (C06506) HEATER KIT
Locate and identify the following parts in the Heater Kit. Hardware and quantities may vary.
QTY PART
NO. DESCRIPTION
1 C06450 Cable Assy., 120 VAC Heater or
C06490 Cable Assy., 240 VAC Heater Relay
2 067165 Square Fiber Washer
2 067126 Washer #8
2 C04037 Screw, 8-32 x 3/8
2 C08759 Screw, 6-32 x 3/8 with lockwasher
2 053652 Screw, #8-32 x 1/4 TT
1 0M0042 Nylon Tie Wrap
1 C09694 Wire Twist Standoff
1.
Turn off the circuit breakers supplying power to the MICRO, LIGHTS and FEED.
2. Unlock and remove the front panel.
3.
Remove the two bolts located over the tabs of the bezel assembly. Lift the
bezel assembly upwards and out to remove.
4.
Loosen, and remove if necessary, two screws located on the left and right
door support brackets and pivot the display panel down.
5.
Repeat Steps 2 through 4 on the other side of the pump.
6. Pull the connector off P1 (a) on the
power supply. After a few seconds,
reconnect P1.