Gasboy 9800A Series - Manual (Page 64)

GASBOY Series 9800A
5-4 03/07/03
REPLACING THE PLATFORM ASSEMBLY
1.
Disconnect the LIGHTS and MICRO connectors [1] from the power bracket.
2. Disconnect the AC, pulser, handle, and DC [2] cables from the CPU PCB and RS-485 or
Pump I/F PCB. Push the cables down through the holes in the platform.
3.
Disconnect the rear lamp cable from the ballast cable [3].
4.
Remove the rear ground braid and its retaining hardware [4] from the platform.
5.
Disconnect the cables [5] from the rear door PCB’s.
6. Remove the hardware [6] securing one of the support brackets. Be careful not to let the
door fall off while removing the screws. Slide the door away from the remaining support
bracket and pull the door out of the cabinet.
7. Remove the four nuts, washers, and lock washers securing the platform assembly to the
chassis.
8.
Go to the front of the chassis (the side with the door still installed) and lift the platform up and
out toward you.
9.
Reverse Steps 1 through 9 to replace the platform assembly.