Gasboy 9800A Series - Manual (Page 7)

03/07/03 1
PARTS LIST
USING THIS PARTS LIST
This manual lists parts information for the Series 9800A pumps and dispensers. Using part
numbers when ordering will expedite your order and reduce the possibility of the wrong parts
being shipped.
This manual is arranged from general to specific, presenting the complete unit first, then the
chassis breakdowns, then further breakdowns of the dial enclosures, discharges, pumping units,
motors, meters and electronics. If you can't find the part you need from the chassis drawing, be
sure to check the appropriate parts breakdown for your model.
Procedures requiring disassembly of portions of the pump/dispenser should be performed by
competent service personnel. Do not depend upon the repair service of a general mechanic
unless he is thoroughly familiar with the mechanism. GASBOY has a distributor network which
services fuel dispensing and management systems in every section of the country.
WARNING:
To reduce the risk of electrical shock when servicing, turn off and lock out all power to the
pump/dispenser. In submersible pump applications, turn off and lock out power to the
submersible pump and any other pumps/dispensers which use that submersible pump. AC
power can feed back into a shut-off dispenser when dispensers share a common submersible
pump or starter relay. Always turn off and lock out all power to the dispenser and submersible
pumps at the master panel and close any impact valve before performing maintenance or service
to the dispenser, including the changing of any fuel filters or strainers. Also block islands so no
vehicles can pull up to the dispenser when the dispenser is being worked on.