Gasboy 215A - Manual (Page 20)

GASBOY 215A/215ATW/216A/216ATW Satellite Dispensing Units
3-6 03/07/03
024319 WIRING DIAGRAM
Models Satellite 215A/9800A Front Load
Twin Satellite, 215ATW/9800A
Satellite 216A/9800A Front Load
Twin Satellite, 216ATW/9800A
NOTES:
1.
All wiring and conduit runs must conform with all building/fire codes, all Federal, State, and
Local codes, National Electrical Code, (NFPA 70), NFPA 30, and Automotive and Marine
Service Station Code (NFPA 30A) codes and regulations. Canadian users must also comply
with the Canadian Electrical Code.
2.
See Weights and Measures Handbook 44 to determine which mode of satellite operation is
relevant for your application. In many cases, the satellite must be wired so it cannot dispense
product while the master dispenser is dispensing and vice versa. Use the correct wiring
diagram according to your application.
3. If using a GASBOY 9800A and satellite in an application where both master and satellite
cannot dispense product at the same time, a minor change in the 9800A wiring must be
made. Wire the dispenser to the satellite as shown in the wiring diagram labeled Non-
Simultaneous.
4.
If this unit is equipped for 230 VAC operation (international), wire as shown in the standard
115 VAC wiring layout diagram.
5. Twin satellite models 215ATW and 216ATW: Although the wiring from both master
dispensers will enter into the same AC junction box, the wiring to the controls for each
satellite hose outlet is to be supplied independently from its corresponding master dispenser.
6.
This wiring diagram is intended only to show the connections between the satellite and the
dispenser. See wiring diagram for master dispenser (according to model number) for
applicable warnings and proper connection of all wires. Consult the 9800A Installation
Manual for full wiring information for the dispenser.