GAI-Tronics 227-005 SMART Auto-Dial Handset Telephones - Manual (Page 22)

Pub. 42004-443C
SMART A UTO -D IAL H ANDSET T ELEPHONES P AGE
20 of 31
f:\standard ioms - current release\42004 instr. manuals\42004-443c.doc
02/13
Command Select Configuration
Factory Setting: Auto
Jumper J20 is required to be in the factory set position. Do not remove the jumper from the PCBA.
AUX2 Input Configuration
Factory Setting: AUX2
Jumper J12 selects an option to use the AUX2 input (TB7) for the cradle hookswitch connection. This
alternate hookswitch wiring to AUX2 would be used in place of the normal hookswitch connection to
clips E3–E4. This is convenient if the 69577 PCBA is used to replace a 69411 PCBA in a 2xx-003
SMART Telephone, or any custom SMART Handset Telephone.
Hookswitch connects to clips E3–E4: J12 in position AUX2.
Hookswitch connects to AUX2: J12 in position HKSW.
Low-Power Mode Configuration
Factory Setting: Low-Power Mode Disabled
For some installations in which only minimal loop current is available, the performance of the telephone
may be improved by enabling this feature. Symptoms of minimal loop current may include low speaker
volume and/or momentary muting of audio. In the majority of applications, however, the low-power
mode should be disabled. The low-power mode is enabled by installing the following three jumpers: J21,
J22, and J23.
Low-Power Mode Enabled: Jumpers installed at J21, J22, and J23.
Low-Power Mode Disabled: Jumpers NOT installed at J21, J22, and J23.
Hardware Settings
Table 1. Hardware Settings Table
Default Settings User Settings
Function Setting Jumper/Position Setting Jumper/Position
Auto-answer Enabled J14/EN
Password Protection Enabled J9/EN Not Applicable
Line Polarity Non-polarized J6/NON
Command Select Auto J20/AUTO Not Applicable
DTMF Gain Select Low Gain J17/LO
AUX2 input is
available for other
functions
(Hookswitch wires to
clips E3-E4) AUX2 J12/AUX2
Low-Power Mode Disabled J21, J22, J23 not
installed