GAI-Tronics 227-005 SMART Auto-Dial Handset Telephones - Manual (Page 10)

Pub. 42004-443C
SMART A UTO -D IAL H ANDSET T ELEPHONES P AGE
8 of 31
f:\standard ioms - current release\42004 instr. manuals\42004-443c.doc
02/13
Security Hardware
Models 227-005 and 277-005 are vandal-resistant, with the front panel for each telephone attached to its
enclosure with security screws. A GAI-Tronics Model 233-001 Security Screwdriver or Torx T-25
security head tip (sold separately) is recommended for installing the security screws. Model 247-005 and
257-005 Telephones’ front panels are attached with standard Phillips head screws.
Conduit Installation Details (Applicable to Models 247-005 and 257-005)
GAI-Tronics recommends installing telephone lines in conduit to protect against accidental damage and
vandalism. To prevent moisture from entering the enclosure, we strongly recommend the following:
 Conduit should enter the enclosure from the bottom.
 If entered from the top, the conduit must be internally sealed to prevent moisture ingress.
 Sealed fittings should be installed at all cable entry points.
 Silicone sealant or equivalent should be applied around and inside all conduit entries.
Refer to Figure 1 and Figure 2.