Flowserve MX-85 Actuator - Manual (Page 50)

Flow Control
Limitorque Actuation Systems
42 MX-85/140 Maintenance and Spare Parts FCD LMAIM1341-00
4.7.3 Optional Drive Sleeve and Baseplate Removal
First remove
1. Remove actuator from mounting adapter.
2. Drain oil.
3. Remove thrust base (subassembly #10) - if fitted. (See Section 4.4.1.)
4. Remove motor (subassembly #4). (See Section 4.1.1.)
5. Remove worm shaft (subassembly #3). (See Section 4.6.1.)
6. Remove side-mounted handwheel (subassembly #16). (See Section 4.3.1.)
7. Remove handwheel worm gear (subassembly #12). (See Section 4.8.1.)
8. Remove clutch and clutch ring (subassembly #16). (See Section 4.9.1.)
9. Remove handwheel declutch (subassembly #5). (See Section 4.2.1.)
STEP 1
Lay actuator on its side with the drive sleeve
horizontal. Using a hex key, remove seven of the
baseplate screws (#11-5).
1
STEP 2
Lay actuator on a table or suitable structure with
one of the screws (#11-5) hanging over the edge.
Remove screw. If needed, rotate actuator around
and remove all other screws.
2