Echo Bear Cat 77353-00 - Manual (Page 5)

3 Inch Trailer Instruction Sheet
1
2
3
4
5
3
3
6
7
3 8
Before placing machine onto trailer, secure the trailer
in a manner that it will not move while mounting.
WARNING
FRONT DISCHARGE - MACHINES SERIAL #
C03477 AND BELOW
Figure 8
1. A hoist or other lifting device will need to be used to lift
the machine into place on trailer.
2. The following are the approximate weights of the
chipper/shredders:
SC3265 - 285 lbs. (129.3 kg)
SC3305 - 255 lbs. (116 kg)
SC3305E (w/o battery) - 255 lbs (116 kg)
SC3342 - 255 lbs. (116 kg)
Ensure that the lifting device used is rated and certified
to lift mvore than the weight of the machine.
3. Remove the wheels from machine
4. Remove the four 5/16" nuts and washers to remove the
front support leg. Once removed, replace the two upper
left and right nuts and washers. Leave the lower left
and right studs blank as these are attachment points
used in a later step.
5. Using a 11/32" to 3/8" size drill bit, drill holes in housing
at locations and measurements detailed in Figures 6
& 7.
6. Once holes are drilled, attach engine mount bracket (1)
to outside hole of front left trailer panel flange (2) using
two 5/16 x 7/8" bolts (3), washers and nuts.
7. Mount engine mount bracket (4) to machine housing
(5) at newly drilled hole location using two 5/16 x 7/8"
bolts (3) and nuts.
8. Set machine onto trailer aligning holes in brackets and
secure bracket to bracket using two 5/16 x 7/8" bolts
(3), washers and nuts.
9. Install trailer base bracket (8) with 2 threaded studs (9)
on front panel using two 5/16" nylock flange nuts. Also
secure the front right plate (4) using four 5/16" bolts
in the two outermost holes on the front and back side
engine mount bracket (5) using four 5/16" bolts (3),
washers and nuts.
*When securing slotted holes use a washer on the bolt side.
1-3/8"
1"
11/32 TO 3/8
HOLE DIAMETER
Figure 6
DRILL
HOLES
Figure 7