Echo Bear Cat 77353-00 - Manual (Page 4)

3 Inch Trailer Instruction Sheet
1
2
3
4
3
5
6
7
7
3
Before placing machine onto trailer, secure the trailer
in a manner that it will not move while mounting.
WARNING
1. A hoist or other lifting device will need to be used to lift
the machine into place on trailer.
2. The following are the approximate weights of the
chipper/shredders:
SC3265 - 285 lbs. (129.3 kg)
SC3305 - 255 lbs. (116 kg)
SC3305E (w/o battery) - 255 lbs (116 kg)
SC3342 - 255 lbs. (116 kg)
Ensure that the lifting device used is rated and certified
to lift more than the weight of the machine.
3. Remove the wheels from machine
4. Remove the four 5/16" nuts and washers to remove the
front support leg. Once removed, replace the two upper
left and right nuts and washers. Leave the lower left
and right studs blank as these are attachment points
used in a later step.
REAR DISCHARGE - MACHINES SERIAL #
C03477 AND BELOW
Figure 5
5. Using a 11/32" to 3/8" size drill bit, drill holes in housing
at locations and measurements detailed in Figures 6
& 7.
6. Once holes are drilled, attach engine mount bracket (1)
to housing (2) at the new holes using two 5/16 x 7/8"
bolts (3), washers and nuts.
7. Lower machine onto trailer with engine mount bracket
(1) holes aligned to holes on front right plate (4) of trailer
securing with 5/16 x 7/8" bolts (3), washers and nuts.
8. Install front support plate (5) with 2 threaded studs (6)
on front panel using two 5/16" nylock flange nuts. Also
secure inside and outside holes on both right and left
trailer flange plates (7) using the four 5/16" bolts (3).
*When securing slotted holes use a washer on the bolt side.
1-3/8"
1"
11/32 TO 3/8
HOLE DIAMETER
Figure 6
DRILL
HOLES
Figure 7