DR Power Tow-Behind 8.00 Premier (Pre-August 2010) - Manual (Page 27)

CONTACT US AT www.DRPower.com or CALL TOLL FREE 1-800-DR-OWNER 23
Connecting the Blower Inlet Vacuum Hose to the Hose Adapter
The following procedure includes the steps necessary for connecting the Blower Inlet Vacuum Hose of the
DR LEAF and LAWN VACUUM to the Hose Adapter.
Tools May Be Needed:
•
Wire Cutters or Hack Saw
•
Knife
•
Screw driver or Nut driver
1. Connect the Hose from the Blower Inlet to the Hose Adapter by aligning the two (2) Flexible
Latches and slipping the end of the Hose over the Hose Adapter (Figure 16).
2. Pull and hook the two (2) Flexible Latches into place (Figure 16) to secure the Hose.
Tip: If the Latches do not align, loosen the Hose Clamp on the Inlet Hose and rotate the Hose
Connector into alignment.
Tip: If there is excess Hose, reduce the length of the Hose by removing the Hose Clamp on the end of
the Hose with a Screwdriver, and cut the Hose to length required using Wire Cutters to cut the
spiral and then cut the Hose between the spirals with the Knife. Then reinstall Hose and Hose
Clamp.
Hose Adapter
Inlet Hose
Figure 16
Pull and Hook
Flexible Latch
Hose Clamp