DR Power Tow-Behind 8.00 Premier (Pre-August 2010) - Manual (Page 20)

16 DR
®
PREMIER LEAF and LAWN VACUUM
1. Place the projecting edges of the two (2) Side
Panels on top of the Trailer with the Side Support
Plates in the slots on the Trailer as shown.
NOTE: The Side Support plates are loosely mounted to
the Side Panels to allow for easy alignment and
expansion of the plastic. Align the holes in the
projecting edges with the holes in the Trailer
Frame. Secure them at each end to the Trailer
Frame with the 5/16" x 2" Wing Screws. Install
a Lock Washer followed by a Flat Washer on
each Wing Screw. Insert the Wing Screws
through the Frame from the outside (Figure 5).
2. Tip the Centrifugal Separator at a 45° angle and
slide it between the secured sides on the Trailer
with the Hose protruding along the right side of
the Trailer pointing toward the front (Figure 6).
3. Place the left edge of the Centrifugal Separator on
top of the left Side Panel (Figure 6).
Tip: You can accomplish this easier with two (2)
people.
4. Lift the Hose side of the Centrifugal Separator and
place it on top of the right Side Panel; align the
holes in the top edges of the Side Panels with the
protruding Pins from the Centrifugal Separator
and secure in place with the Flexible Latches
(Figure 7).
Tip: Push out in the middle of the top of the Side
Panel to help seat the Pin in the hole in the
middle of the top edge of the Side Panel.
Collector Box Installation
The following procedure includes all of the steps
necessary for the installation of the Collector Box on the
DR LEAF and LAWN VACUUM.
Wing Screw
4 places
Latches
Panels Inserted
in Slots
Figure 5
Figure 6
Figure 7
Pin in Hole
Push Out