DR Power Tow-Behind 8.00 Premier (Pre-August 2010) - Manual (Page 21)

CONTACT US AT www.DRPower.com or CALL TOLL FREE 1-800-DR-OWNER 17
Figure 9
Figure 8
Attach over Pins
Flexible
Latches
6 places
Tilt Bed Back
Attach over Pins
Flexible
Latches
6 places
5. Attach the Front Enclosure Panel on the
protruding support Pins and fasten the
sides, top and bottom using the six (6)
Flexible Latches (Figure 8). Note the
difference between the Front and Rear
Panels. The Rear Panel has the metal
edge supports. The mounting holes are
located on top of the Panels.
Tip: For ease of attaching the Front Cover,
release the Dump Latch and tilt the
Body back. Set the Front Panel over
the protruding Pins, one side at a time,
making certain that the six (6) Flexible
Latches are on the outside of the
Panels (Figure 8).
6. Lower the Bed and secure in place with
the Dump Latch (Figure 4 on page 14).
Attach the Rear Panel on the protruding
Pins and secure in place with the six (6)
Flexible Latches (Figure 9).
Tip: Set the Rear Panel over the protruding
Pins, one side at a time, making sure
to keep the Flexible Latches on the
outside of the Box.