DNF Controls ST420-VSS - Manual (Page 12)

Page 8 of 21 ST420-VSS User Manual
e) Set Spyder IP Address
1) Press the [VIEW SPYDER IP ADR] key (shotkey #4). The Spyder
IP Address is displayed in four keys in the upper right section of the
keyboard. The key with green illumination is the active field. Use
the [<<<<} or [>>>>] keys to select the field that you want to
change.
2) Enter the IP address assigned to the Spyder that Shotbox will
control. Use the displayed numeric keypad on the Shotbox.
3) Press the [ENTER] key to save the entered Spyder IP Address.
OR
Press the [ESC] key or [BACK] key (shotkey #30) to exit without
saving changes.
f) Save LANTRONIX Configuration
1) Press the [SAVE] key (shotkey #21).
2) The LANTRONIX configuration will be saved in non-volatile
memory inside the LANTRONIX adaptor. This must be done for
any configuration changes to take affect. The diagnostic LED on
the LANTRONIX adaptor will turn off.