DNF Controls ST420-VSS User Manual
Page 11
ST420-VSS User Manual
Page 7 of 21
c) Set Subnet Mask
1) Press the [VIEW SUBNET MASK] key (shotkey #2). The Subnet
Mask is displayed in four keys in the upper right section of the
keyboard. The key with green illumination is the active field. Use
the [<<<<} or [>>>>] keys to select the field that you want to
change.
2) Enter the Subnet Mask for the IP address entered in #B above
using the displayed numeric keypad on the Shotbox. (For example,
enter 255.255.255.0 for a Class C IP address). If not sure, enter
255.255.255.0.
3) Press the [ENTER] key to save the entered Subnet Mask.
OR
Press the [ESC] key or [BACK] key (shotkey #30) to exit without
saving changes.
d) Set Gateway
1) Press the [VIEW GATEWAY] key (shotkey #3). The Gateway IP
Address is displayed in four keys in the upper right section of the
keyboard. The key with green illumination is the active field. Use
the [<<<<} or [>>>>] keys to select the field that you want to
change.
2) Enter the Gateway IP address using the displayed numeric keypad
on the Shotbox. If the Spyder and Shotbox are connected to the
same ethernet hub or switch, enter 0.0.0.0.
3) Press the [ENTER] key to save the entered Gateway address.
OR
Press the [ESC] key or [BACK] key (shotkey #30) to exit without
saving changes.