Installation, A. evs mode off, B. evs mode on and evs maxs setup – DNF Controls ST300-EVS User Manual
Page 6: A. evs, Mode
ST300-EVS & ST300-EVS-T, Slow Motion Controller
6
6
o
o
f
f
2
2
4
4
3. INSTALLATION
Select a. OR b. below.
a.
EVS
MODE
OFF
1)
Plug one end of a 9-conductor, RS422 serial cable into the VTR1, VTR2, VTR3,
OR VTR4 connector on the rear of the SLOW MOTION CONTROLLER. Plug
the other end of the cable into the 9-pin REMOTE connector on the VTR.
2)
Connect the supplied POWER SUPPLY, APX#4108, into the POWER
connector on the rear of the ST300. Plug the Power Supply into an outlet, 90
VAC – 240 VAC.
3)
Select REMOTE mode on the VTR's front panel.
4) Check
the
SETUP MENU prior to using the Slow Motion Controller to confirm
proper Record mode, SLO-MO speed range, and other User settable modes.
OR
b.
EVS MODE ON and EVS maXS SETUP
1)
EVS MODE ON
a)
Connect VTR1 connector on the back of the ST300 to the REMOTE1
connector on the back of the maXS DDR using a standard RS422 serial
cable.
b)
Connect VTR2 connector on the back of the ST300 to the REMOTE2
connector on the back of the maXS DDR using a standard RS422 serial
cable.
c)
Connect VTR3 connector on the back of the ST300 to the REMOTE3
connector on the back of the maXS DDR using a standard RS422 serial
cable.
d)
Connect VTR4 connector on the back of the ST300 to the REMOTE4
connector on the back of the maXS DDR using a standard RS422 serial
cable.
2) EVS
maXS
SETUP
a)
Select “1 maXS BVW-75” from the Application List.
b)
Press F8 to go into Audo Video Channel Parameters setup.
c)
Select “SONY-DD35 Slave” Base config.
d)
Press F3 to go to Advanced config. setup.
e)
Select “DD35” control for channels 1 and 2.
f)
Select “SONY” control for channels 3 and 4.
g)
Press ALT + Q to exit setup.
h)
Press ENTER to start EVS.