DNF Controls ST300-EVS - Manual (Page 17)

ST300 SETUP
Press Softkey beneath ClearCues to clear all Cue Points to 00:00:00:00.
Press Softkey {YES} when asked “Are You Sure?”
Press Softkey beneath SetDefault to set ST300 to default settings.
Press Softkey {YES} when asked “Are You Sure?”
DISPLAY
SOFTWARE
VERSION
The version number for the currently installed software is displayed.
DROP
FRAME
Press Softkey to select DROP FRAME {ON} or {OFF}.
Used to preset the VTR’s Timecode Generator.
RECORD Press Softkey to select single button or 2-button record.
RECORD = {REC} Only
OR
RECORD = {REC} + {PLAY}
FREEZE Press Softkey to enable or disable FREEZE at Record Outpoint. Changing mode
automatically clears FREEZE point.
GUARD BAND Using the keypad, enter a value between 0 – 30 seconds.
Used to specify the amount of video to include in a created clip before the IN point and
after the OUT point.
VIDEO
STANDARD
Press softkey to select:
{NYSC}, {PAL} OR {24P}.
TRANSMIT
CUELIST
Transmits Cuelist to another ST300 or to a PC.
RECEIVE
CUELIST
Receives Cuelist from another ST300 or a PC.
ST300 SETUP
Clear Cues SetDefault
ST300-EVS & ST300-EVS-T, Slow Motion Controller 1 1 7 7 o o f f 2 2 4 4