DNF Controls ST300-EVS - Manual (Page 15)

ST300-EVS & ST300-EVS-T, Slow Motion Controller 1 1 5 5 o o f f 2 2 4 4
Reference . . .
7. SETUP MENU
‰ Press [MENU]. The MENU indicator will turn on. Turn the Wheel to select item to change.
‰ Use the Softkeys to change the desired mode for that option. Turn the Wheel at anytime to
select another item.
‰ Press [ESC] at anytime to exit SETUP MENU. The MENU indicator will turn off.
MENU MODES (Turning Wheel Clockwise)
RECORD Press [MENU] to select the desired record mode:
Lockout, Assemble, Crash (Full) or Insert.
Only in INSERT mode: Press the associated Softkey, located below the display, to toggle
Video(V), Audio1(A1), Audio2(A2), Audio3(A3), Audio4(A4) on/off.
MARK-Q Press Softkey to:
Enable {ADVANCE} to next Cue Point, when [MARK] is pressed.
OR
Maintain {CURRENT} Cue Point when [MARK] is pressed.
EVS MODE Press Softkey to select:
EVS MODE {OFF} ST300 works like the standard ST300 and does not use
EVS maXS functions.
EVS MODE {ON} ST300 uses EVS maXS functions. Connect ST300 to
EVS maXS using EVS MODE ON Connection Diagram.
WIND MODE Press Softkey to select:
{HOLD} (Fast wind is maintained only while key is pressed.)
OR
{LATCH} (Fast wind is initiated and maintained with momentary key press.)
Select fast wind speed (3.9 to 23.7) by pressing Softkey below {SPD}.