DNF Controls ST300-EVS - Manual (Page 12)

ST300-EVS & ST300-EVS-T, Slow Motion Controller 1 1 2 2 o o f f 2 2 4 4
f. CREATE A CLIP
1)
Select a Page and enter a Cuepoint number of a clip you wish to load.
OR
Use [LAST CUE], [NEXT CUE] to select a desired Cuepoint.
2) Press [MARK] key to mark a cuepoint and save the IN point of the clip.
3) Press [OUT] key to save the OUT point of the clip and create a clip with the
same name as a cuepoint number on a corresponding channel.
If an OUT point is marked with a previously marked IN point, the OUT point
will be displayed and the OUT LED will be illuminated. When an IN point is
then selected with the [MARK] key, a clip will be created with the
corresponding IN and OUT point.
NOTE: “xxxA” clips are created on VTR1, “xxxB” clips are created on VTR2.
For Example:
a) Select
VTR1
b)
Mark Cuepoint 123 with time 15:23:44:10
c)
Press OUT at TC = 15:24:15:00
d)
The clip “123A” is created with IN point = 15:23:44:10
and OUT point = 15:24:15:00
Another
Example:
a) Select VTR1
b) Select Cuepoint 124
c) Press OUT at TC = 15:24:20:00
d) Press MARK at TC = 15:24:19:00
e) The clip “124A” is created with IN point = 15:24:19:00
and OUT point = 15:24:20:00
g. LOAD A CLIP
1)
Select a Page and enter a Cuepoint number of a clip you wish to load.
OR
Use [LAST CUE], [NEXT CUE] to select a desired Cuepoint.
2) Press [SHIFT] + [GOTO] to load a corresponding clip on a corresponding
channel.
NOTE: “xxxA” clips are loaded on VTR1, “xxxB” clips are loaded on VTR2.