DNF Controls 2044CL-L-PBIO - Manual (Page 9)

2044CL-L-PBIO, 300 Clip Fast Access System, Louth Protocol Page 9 of 27
6. LEARN A CLIP OR CLIP COMBINATION
a. ON THE ST400
1) Press
VTR [1], [2], [3], [4], [5], or [6].
2)
Load a clip on the selected channel. See section LOAD A CLIP.
3)
Use the transport functions to view the clip.
Press [IN] to mark an IN point. The IN LED will blink. On recall, the clip will
cue to the IN time, not the beginning of the clip and the LED will stay on steady.
Optional- Press [OUT] to mark an OUT point. The OUT LED will blink.
On recall, the clip will play to the OUT point then stop.
To delete an IN or OUT point, press and hold [DEL], then press [IN] or [OUT].
The IN/OUT LED will turn off.
If no IN point is marked, the current location of the clip will be learned as the IN
point.
4)
For GANGs, repeat steps 1), 2) and 3) for each channel. Then press the {GANG}
softkey.
Press VTR [1], [2], [3], [4], [5], or [6] to add the VTR to the GANG. The VTR
LED will turn on.
Press the VTR key again to remove it from the gang. The VTR LED will turn
off.
Press [ESC] to exit GANG mode. The LED of all GANGed VTRs will turn on.
5)
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or by
manually entering the Cue Point using the numeric keypad, followed by
[ENTER].
The selected Cue Point number is shown on the bottom part of the display.
6)
Press [SHIFT] + [MARK] to initiate the Learn.
The display will show: “Select VTRs to learn:--------”
7)
Select the VTRs to be learned by pressing VTR keys [1], [2], [3], [4], [5], and/or
[6].
8) Press
{LEARN} or [MARK] to complete the Learn process.
NOTE: Learn will overwrite the previous contents of the Cue Point.
Press [ESC] at anytime to escape without LEARNing.