DNF Controls 2044CL-L-PBIO - Manual (Page 10)

2044CL-L-PBIO, 300 Clip Fast Access System, Louth Protocol Page 10 of 27
b. ON THE SHOTBOX
1) Press
[LEARN]. The LEARN indicator will turn on.
2)
Select the desired BANK by pressing BANK [1], [2], [3], [4], [5], [6], [7], [8],
[9], or [0].
3)
Press the desired Shotkey to complete the learn process.
The learned CLIP ID is displayed on the Shotkey.
LEARN will save the CLIP ID on the channel selected in step #1, the IN and
OUT points marked in step #2, and the GANG configuration selected in step #3.
NOTE: LEARN will overwrite the previous contents of the Shotkey.
3) Press [LEARN] at anytime to escape without LEARNing.
c. ON THE PRODUCTION SWITCHER
Select and enable the Peripheral Device Addresses for the ST400 VTRs to learn.
LEARN to the desired EMEM or SNAPSHOT register.
NOTE: LEARN will overwrite the previous contents of the Shotkey.
7. RECALL A CLIP OR CLIP COMBINATION
a. ON THE ST400
1) Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or by
manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom of the display.
2) Press [LOAD] on the ST400.
The ST400 will automatically load the learned clips on the learned VTRs.
Cue the clips to the learned IN time.
b. ON THE SHOTBOX
1) Select the desired BANK by pressing BANK [1], [2], [3], [4], [5], [6], [7], [8],
[9] or [0].
The Shotkeys will display the assigned CLIP IDs for the selected bank.
2) Press the desired Shotkey.
The selected clip or clip combination will be loaded on the learned channels, and
cued to the learned IN point. The learned OUT point and GANG mode will be
set.