DNF Controls 2044CL-L-PBIO - Manual (Page 12)

2044CL-L-PBIO, 300 Clip Fast Access System, Louth Protocol Page 12 of 27
10. LOOP CLIP
ON THE ST400
a.
Load the clip using CLIP LIST, or recall a cue point.
(The clip MUST be loaded from the 2044CL.)
b.
Optional: Set an IN Point and/or OUT Point.
Jog/Shuttle to the desired IN point. Press [IN].
Jog/Shuttle to the desired OUT point. Press [OUT].
OR
Press [SHIFT] + [IN]. Manually enter the IN time on the numeric keypad. Press
[ENTER].
Press [SHIFT] +[OUT]. Manually enter the OUT time on the numeric keypad. Press
[ENTER].
c. Press
[LOOP ENABLE].
The clip will immediately start looping.
NOTE: If the CLIP ID ends with an asterisk (“*”), it will automatically loop when either [LOOP
ENABLE] or [PLAY] is pressed.
11. PLAY CLIP SEGMENT
a. Set an IN Point and OUT Point.
Jog/Shuttle to the desired IN point. Press [IN]. The IN LED will blink.
Jog/Shuttle to the desired OUT point. Press [OUT]. The OUT LED will blink.
OR
Press [SHIFT] + [IN]. Manually enter the IN time on the numeric keypad. Press
[ENTER].
Press [SHIFT] + [OUT]. Manually enter the OUT time on the numeric keypad. Press
[ENTER].
b. Learn the segment into a cuepoint.
b. Recall a cuepoint.
The IN and OUT LEDs turn on steady.
c. Press [PLAY]. The clip will play to the OUT point, then stop.
NOTE: If IN & OUT LEDs blink, the clip will not stop at the OUT point. It will only stop at the
OUT point of LEDs are on steady.