DNF Controls 2044CL-L-PBIO - Manual (Page 14)

2044CL-L-PBIO, 300 Clip Fast Access System, Louth Protocol Page 14 of 27
Advanced Features . . .
14. CREATE A CLIP
a. In the Setup Menu, configure Louth port as Input Port.
b. Press [CLIP LIST].
c. Press {CREATE}. The display will show the default CLIP ID.
d. Press
[LOAD] to accept the default CLIP ID.
OR
Manually enter an ID with a maximum of 32 characters from the ST400 numeric keypad.
OR
Manually enter an ID with a maximum of 32 characters from a PC keyboard.
e. Press
{CREATE}. The clip will be created and loaded.
If the entered CLIP ID already exists, a warning message will be displayed. Press any key
to rename clip.
Press [RECORD] to start recording.
OR
Press [ESC] to exit without loading the existing clip.
15. SHOTBOX SHOTKEY MAPPING TO SHOTLIST
LOCATIONS
The Shotkeys on the Shotbox access the cue point locations in the ST400 as follows:
BANK 0, Shotkeys 1 Æ 30 access cue point locations 001 Æ 030 and E-mem registers 01Æ 30..
BANK 1, Shotkeys 1 Æ 30 access cue point locations 101 Æ 130 and E-mem registers 31Æ 60.
BANK 2, Shotkeys 1 Æ 30 access cue point locations 201 Æ 230 and E-mem registers 61Æ 90..
BANK 3, Shotkeys 1 Æ 30 access cue point locations 301 Æ 330 and E-mem registers 91Æ 99..
BANK 4, Shotkeys 1 Æ 30 access cue point locations 401 Æ 430.
BANK 5, Shotkeys 1 Æ 30 access cue point locations 501 Æ 530.
BANK 6, Shotkeys 1 Æ 30 access cue point locations 601 Æ 630.
BANK 7, Shotkeys 1 Æ 30 access cue point locations 701 Æ 730.
BANK 8, Shotkeys 1 Æ 30 access cue point locations 801 Æ 830.
BANK 9, Shotkeys 1 Æ 30 access cue point locations 901 Æ 930.
16. SHOTBOX CONTROL SWITCHES
a.
[PLAY]: Plays out the selected clip.
b.
[RECUE]: Returns to the IN point of the clip.
c.
[STOP]: Stops playout of the clip.