DNF Controls 2044CL-L-PBIO - Manual (Page 13)

2044CL-L-PBIO, 300 Clip Fast Access System, Louth Protocol Page 13 of 27
12. PBIO ENABLE/DISABLE
ON THE ST400
Press the {PBIO} softkey to enable or disable PBIO. When disabled, the ST400 will ignore all
Pbus commands. When enabled, the ST400 will respond to all Pbus commands.
When enabled and Pbus commands are received, the softkey’s LED will flash.
13. PRODUCTION SWITCHER PBIO TRIGGER VALUES
The Production Switcher outputs a Peripheral Bus trigger at specific Timeline key frames, as
programmed by the operator. The 2044CL performs a specific function for each trigger value:
GRASS VALLEY GROUP PRODUCTION SWITCHER
Trigger Value
Mode
0 Play (if OUT point is specified, stop at OUT, if clip ends with
“*”, Loop Play)
1 Recue to beginning of clip
2 Slo-mo using ST400 Preset Speed
3 Reverse Play
4 Still Frame
5 Loop
6 Record
7 or greater Play
SONY PRODUCTION SWITCHER
Trigger Value Mode
0 Recue to beginning of clipPlay
1 Play (if OUT point is specified, stop at OUT, if clip ends with
“*”, Loop Play)
2 Slo-mo using ST400 Preset Speed
3 Reverse Play
4 Still Frame
5 Loop
6 Record
7 or greater Play
To control more than one VTR, enable the Peripheral Device Address for each VTR. The Trigger
value will be sent to the enabled devices.
OR
GANG the required VTRs on the ST400. See FUNCTION TABLE for GANG instructions.
Enable the Peripheral Device Address for one of the GANGed VTRs. The Trigger will be sent to
the enabled VTR. The other VTRs in the GANG will perform the same action.