DNF Controls 2034CL-SX-PBIO - Manual (Page 8)

8 2034CL-SX-PBIO, 300 Clip Instant Access System, Sony SX Protocol
6. SETUP MENU
Press [MENU]. The MENU indicator will turn on.
Turn the Wheel to select item to change.
Press [MENU] OR use the Softkeys to change the desired mode for that option.
Turn the Wheel at anytime to select another item.
Press [ESC] at anytime to exit SETUP MENU. The MENU indicator will turn off.
MENU MODES:
(Turning Wheel clockwise)
RECORD Press
[MENU] to select the desired record mode:
Lockout, Assemble, Crash (Full) or Insert.
Only in INSERT mode: Press the associated Softkey, located below the
display, to toggle Video(V), Audio1(A1), Audio2(A2), Audio3(A3) on/off
WIND
Press Softkey to select:
MODE HOLD (fast wind is maintained only while key is depressed)
OR
LATCH (fast wind is initiated and maintained with momentary key press)
Select fast wind speed (3.9 to 23.7) by pressing Softkey below SPD.
SLOMO
ST300 display shows:
Press Softkey [TBAR] (or [WHEEL]) to toggle between them.
The T-BAR has a speed range of 0Î+200 with a detent at +100 % play
speed OR a range of 0Î+100 (detent at +100 % Play speed).
For Wheel only:
Press Softkey [SPEED] to select SLOMO speed ranges:
Press Softkey to select: 0 ->+200 OR -100 -> +200.
Press Softkey [BACK] to return to SLOMO MENU.
Press [ESC] to exit OR turn the Wheel to select another item.
For Wheel only:
Press Softkey [PRSET] to select the SLOMO Preset Speed Mode
Press Softkey [UPDATE]
When exiting SLOMO mode,
the last used speed is saved in the Preset Speed register.
Press Softkey [STATIC]
ThePreset Speed register is NOT updated when exiting SLOMO mode
It is only changed by [SHIFT] + [SLOMO] (PRESET SLOMO).
SLOMO with: WHEEL
TBAR Speed Prset