DNF Controls 2034CL-SX-PBIO - Manual (Page 5)

5 2034CL-SX-PBIO, 300 Clip Instant Access System, Sony SX Protocol
Getting Started . . .
3. SYSTEM INSTALLATION
SHOTBOX
1.
Plug one end of a standard 9 pin, RS422 serial cable, into the OUTPUT
connector on the rear of the SHOTBOX. Plug the other end of the cable
into the AUX connector on the rear of the ST300.
2. Connect the 5 VDC, 1Amp POWER SUPPLY into the POWER connector on the
rear of the SHOTBOX. Plug the Power Supply into an outlet, 90VAC - 240VAC.
ST300-S/SM, VTR/DDR CONTROLLER
1.
Plug one end of a 9 conductor, RS422 serial cable into the VTR 1(2 or 3)
connector on the rear of the ST300. Plug the other end of the cable into the
REMOTE connector on the SX Hybrid Machine.
2. Connect the +5, +12, -12 VDC POWER SUPPLY into the POWER connector on
the rear of the ST300. Plug the Power Supply into an outlet, 90 VAC - 240 VAC.
3. For frame accuracy on Ver 3.0 ST300, plug video sync reference into the video
reference connector and enable SYNC in the ST300’s MENU.
4. Check SETUP MENU prior to using the ST300 to confirm proper Record mode
and other User settable modes.
PRODUCTION SWITCHER
1.
Connect a standard cable (RS422, 9 pin serial cable) to the supplied turnaround
adapter. Plug the turnaround adapter into the “VTR4” connector on the rear of the
ST300. Connect the other end of the cable to the Peripheral Bus Connector on the
production switcher. (Communication Format- 38.4K, N, 8,1)
2. The ST300 has 3 Peripheral Device Addresses, one for each VTR that it controls.
To set the Device Address for each VTR:
3. Press [MENU] on the ST300.
4. Turn the Wheel clockwise until “Peripheral Address” is displayed.
5. Press VTR [1], VTR[2] or VTR[3] to select a VTR.
Installation is complete.